Zeta potential of bacteria cells: Effect of wash buffers
- Published
- Accepted
- Subject Areas
- Biotechnology, Environmental Sciences, Microbiology
- Keywords
- zeta potential, surface charge, nonspecific adsorption, wash buffer, Escherichia coli
- Copyright
- © 2016 Ng et al.
- Licence
- This is an open access article distributed under the terms of the Creative Commons Attribution License, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.
- Cite this article
- 2016. Zeta potential of bacteria cells: Effect of wash buffers. PeerJ Preprints 4:e110v4 https://doi.org/10.7287/peerj.preprints.110v4
Abstract
Zeta potential, defined as the electric charge at the shear plane, is widely used as a proxy for bacteria cell surface charge. Nonspecific adsorption of ions or polyelectrolytes onto the cell surface, however, alters the value and polarity of the measured zeta potential, leading to erroneous results. Multiple wash and centrifugation steps are commonly used in preparing cells for zeta potential analysis, where various wash buffers (such as 9 g/L NaCl, 0.001M KCl, and 0.1M NaNO3) are routinely used for removing (by charge screening) ions and charged molecules that bind nonspecifically to the cell surface. Preliminary data showed that, for Escherichia coli DH5α (ATCC 53868) grown in LB Lennox (with 2 g/L glucose, or LBG), the zeta potential-pH profile was not significantly different over the pH range from 2 to 12 for deionized water, 9 g/L NaCl, and phosphate buffer saline (PBS) wash buffers. As LBG is a low salt medium without a phosphate buffer, it was likely that the extent of nonspecific adsorption of ions on the cell surface was not substantial, and the different wash buffers would correspondingly not affect measured zeta potential much. For E. coli grown in a semi-defined medium (with a high capacity phosphate buffer system), the zeta potential-pH profile was significantly different over the pH range from 1 to 12 for deionized water, 9 g/L NaCl, 0.1M NaNO3, 0.1M sodium acetate, and 0.1M sodium citrate wash buffers with the extent of difference positively correlated with wash buffer’s ionic strength. Furthermore, the point of zero charge (pHzpc) for E. coli grown in the semi-defined medium varies between 1.5 and 3, in an ionic strength-dependent manner, for the various wash buffers tested. Collectively, this preliminary study suggests that wash buffers' ionic strength strongly affect removal efficiency of nonspecifically absorbed ions on bacteria surfaces, where a threshold exists (0.15M) for charge screening to be effective. At the upper bound, 0.6M ionic strength might result in removal of cations that stabilizes the cell envelope; thus, leading to possible cell surface damage and erroneous measurements.
Author Comment
Text was improved and language polished in this new update of a preprint.